Strongly designed Two-Roll Mills of any size and for any application are ready to our customer´s disposal. Many years experience on this field is transferred on very powerful equipment.
Having a full control on manufacturing process on the mill rolls give us a large advantage. Buzuluk is provided with its own foundry for casting the mill rolls. The mould cast iron rolls are completely machined in our machining shop. The working surface hardness is 500 ± 20 HBr, depth of hardened layer 10 to 15 mm. Such material properties make the Buzuluk rolls the top quality product.
Both cooling design solutions are available.
Cored design with low purchase cost, short delivery time and minimum maintenance activities bring standard solution for many operations. On the other side when the good temperature control or maximum cooling effect is required the peripherical drilled rolls are the only suitable alternative.
Below specified Two-Roll Mill capacities are offered.
Type of machine
Diameter of the rolls
Typical length of the rolls
Typical speed of the rolls
1,6 - 15
1 - 11
3,3 - 33
Recommended drive power for single friction ratio
55 nebo 75
Recommended drive power for variable friction ratio
2 x 7,5
2 x 7,5
2 x 45
2 x 55
2 x 75
2 x 90
2 x 132
2 x 160
Cooling water consumption
Remark: Type 03876 is to be used for laboratory purposes only.
The length of the rolls may slightly differ if required by the customer.
Cooling water consumption is calculated based on standard triple pass drilled rolls excl. stockblender.
Each Mill size can be provided with various type of auxiliary equipment like Stockblender, cutting knives, drive configurations and orientations, etc. It is always designed to fit our customer needs.
Complete safety system is designed to meet the requirement of EU 1417.
Mechanical or hydraulic roll gap adjustment fulfills maximum operational comfort with fast response for changing the gap is required.
Traditional mechanical drive or hydraulic drive is quoted. Both systems can be delivered in an alternative for single friction but at the same time variable friction is possible.